© National Instruments Corporation 3 BNC-2111 Installation Guide
What You Need to Get Started
To set up and use your BNC-2111 accessory, you need the following:
❑ BNC-2111 BNC accessory
❑ BNC-2111 Installation Guide
❑ Cable for connecting your DAQ device to the BNC-2111. Refer to the
Choosing a Cable section for information on which cable to use for
your DAQ device.
❑ M Series or E Series Multifunction DAQ Device
For detailed specifications for the BNC-2111, refer to the Specifications
section.
Caution Do not connect the BNC-2111 to any device other than the National Instruments
devices listed in the Choosing a Cable section. Doing so can damage the BNC-2111, the
DAQ device, or the host computer. National Instruments is not liable for damage resulting
from these connections.
Choosing a Cable
Refer to Tables 1 through 5 to choose the correct cable for your DAQ
device.
Table 1. 68-Position VHDCI I/O Connector
DAQ Device Connector Diagram
NI 6220/6221
NI 6250/6251
NI 6280/6281
NI DAQCard-6024E
NI DAQCard-6036E
NI DAQCard-6062E
DAQ Device
SHC68-68-EPM
Cable
BNC-2111
To Next Page
Loading...