National Instruments CompactRIO sbRIO-9603 - Page 56

Figure 41. sbRIO-96xx Pedestal Dimensions
34.5 mm (1.36 in.)
44.5 mm (1.75 in.)
50.2 mm (1.98 in.)
68.2 mm (2.68 in.)
70.3 mm (2.77 in.)
76.3 mm (3.00 in.)
90.1 mm (3.55 in.)
53.1 mm (20.9 in.)
56.7 mm (2.23 in.)
70.1 mm (2.76 in.)
72.8 mm (2.87 in.)
67.2 mm (2.64 in.)
86.2 mm (3.39 in.)
90.1 mm (3.55 in.)
0.0 mm (0.00 in.)
19.3 mm (0.76 in.)
29.9 mm (1.18 in.)
32.0 mm (1.26 in.)
35.7 mm (1.41 in.)
41.7 mm (1.64 in.)
39.2 mm (1.54 in.)
81.5 mm (3.21 in.) 77.3 mm (3.13 in.)
75.5 mm (2.97 in.)
55.5 mm (2.18 in.)
51.2 mm (2.02 in.)
30.8 mm (1.21 in.) 35.2 mm (1.39 in.)
15.6 mm (0.61 in.)
17.6 mm (0.69 in.)
96.6 mm (3.68 in.)
75.6 mm (2.98 in.)
77.8 mm (3.06 in.) 67.8 mm (2.67 in.)
62.0 mm (2.44 in.)
33.4 mm (1.31 in.)
48.0 mm (1.89 in.)
8.4 mm (0.33 in.)
10.2 mm (0.42 in.)
2.4 mm (0.10 in.)
0.0 mm (0.00 in.)
A
B
J
I
H
G
F
E
D
C
Table 22. Pedestal Height from Board Surface
Designation
Pedestal Corresponding
Component Pedestal Height from Board Surface
2
A
FPGA (75T) 2.4 mm (0.094 in.)
FPGA (100T) 2.4 mm (0.094 in.)
FPGA (200T) 3.3 mm (0.130 in.)
B OSC 2.4 mm (0.094 in.)
C NI ASIC 1 2.6 mm (0.102 in.)
2
Using a 1.5 mm (0.06 in.) thick thermal gap-filler.
56 | ni.com | CompactRIO Single-Board Controller with NI-DAQmx Hardware Installation Manual