National Instruments GPIB-USB Series User Manual

Chapter 1 GPIB Hardware
GPIB Hardware Guide 1-10 ni.com
Figure 1-6. Installing the PMC-GPIB
5. Use the mounting hardware provided to fasten the PMC-GPIB to the
host.
6. Reinstall the host, if you removed it to install the PMC-GPIB.
7. Power on your system.
The PMC-GPIB hardware installation is now complete.
1 Host Face Plate
2 3.3 V Keying Hole
3 5 V Keying Hole
4 PMC-GPIB Board
5 Mounting Screws
5
1
2
3
4

National Instruments GPIB-USB Series Specifications

General

Bus Interface	USB
Dimensions	Varies by model
Weight	Varies by model
GPIB Standard	IEEE 488
Operating System	Linux
Compatibility	IEEE 488.1 and IEEE 488.2
Power Supply	Powered via USB