National Instruments GPIB-USB Series User Manual

Appendix A Specifications
GPIB Hardware Guide A-8 ni.com
All Devices
Altitude ...................................................2,000 m (at 25 °C ambient
temperature)
Pollution Degree .....................................2
Indoor use only
Safety
This product is designed to meet the requirements of the following
standards of safety for information technology equipment:
• IEC 60950-1, EN 60950-1
• UL 60950-1, CSA 60950-1
Caution Overloading the circuits may damage supply wiring. Do not exceed the ratings on
the equipment nameplate when connecting equipment to the supply circuit.
Note For UL and other safety certifications, refer to the product label or the Online
Product Certification section.
Electromagnetic Compatibility
This product meets the requirements of the following EMC standards for
electrical equipment for measurement, control, and laboratory use:
• EN 61326 (IEC 61326): Class A emissions; Basic immunity
• EN 55011 (CISPR 11): Group 1, Class A emissions
• AS/NZS CISPR 11: Group 1, Class A emissions
• FCC 47 CFR Part 15B: Class A emissions
• ICES-001: Class A emissions
Note For the standards applied to assess the EMC of this product, refer to the Online
Product Certification section.
Note For EMC compliance, operate this device with shielded cabling.

National Instruments GPIB-USB Series Specifications

General

Bus Interface	USB
Dimensions	Varies by model
Weight	Varies by model
GPIB Standard	IEEE 488
Operating System	Linux
Compatibility	IEEE 488.1 and IEEE 488.2
Power Supply	Powered via USB