National Instruments Graphical User Interface Ultiboard - Page 278

Index
NI Ultiboard User Manual I-4 ni.com
guides
moving, 4-10
placing, 4-10
removing, 4-10
using, 4-10
H
help, technical support, C-1
highlighting in Multisim, 4-35
I
initial routing, 7-7
in-place edit
using, 4-29
In-Place Part Edit command, A-7
instrument drivers (NI resources), C-1
interface elements, 1-1
J
jumper properties, 4-23
jumpers
default pin diameters, 1-15
placing, 4-23
K
Keep-in/Keep-out areas
placing, 5-7
properties, 5-7
KnowledgeBase, C-1
L
lamination settings, 3-1
layers
adding to board, 1-24
choosing how many, 3-1
lamination settings, 3-1
multi--layered boards, 3-1
number on the board, 1-24
PCB layers, 3-3
removing from board, 1-24
swapping parts on, 4-11
tab, using, 3-3
Layers tab
using, 3-3
leave drill holes open, 8-14
lines
placing, 4-21
Lock command, A-5, A-23
M
manual trace
placing, 5-2
measurement guides, 4-10
mechanical CAD
colors, 10-3
dimensions, 10-5
paths, 10-5
properties, 10-3
workspace elements, 10-4
mechanical CAD design
creating, 10-2
importing DXF file, 10-3
mechanical CAD files
creating, 10-1
mitering corners, 8-6
modes, 2-8
mounting holes
placing, 4-21
multi-layered boards, 3-1
N
National Instruments support and
services, C-1
NC drill properties, 8-11