National Instruments Graphical User Interface Ultiboard - Page 279

Index
© National Instruments Corporation I-5 NI Ultiboard User Manual
net
adding, 5-21
deleting, 5-25
deleting pad from, 5-26
renaming, 5-25
Net Edit dialog
Groups tab, 5-27
Via tab, 5-28
Net edit dialog
High Speed tab, 5-26
Misc tab, 5-27
Net Shielding dialog, 5-28
netlist
importing, 2-2
netlist check
running, 8-8, A-14
Netlist Editor
about, 5-20
opening, 5-20
Nets tab
using, 5-19
New command, A-1
New Group Array Properties dialog, 4-12
New Project command, A-1
NI support and services, C-1
O
Open command, A-1
open trace ends, deleting, 8-8
optimization, 7-8
Options command, A-20
Orientation command, A-6, A-23
P
pads
deleting from net, 5-26
Part Wizard
using, 4-36
parts
adding to database from design, 4-45
adding to database using command, 4-45
adding to database using Database
Manager, 4-45
aligning, 1-8, 4-11
angle of, 4-11
centroids properties, 8-13
creating using Database Manager, 4-35
creating using the Part Wizard, 4-36
dragging, 4-7
editing (once placed), 4-29
finding, 4-4
flipping, 4-11
locating in open design, 4-34
locking, 4-4
orienting, 4-11
placing from the database, 4-27
placing multiple, 4-3
placing single, 4-3
placing using Design Toolbox, 4-2
position, 4-17
pre-placing, 7-2
previewing, 4-4
properties, 4-17
relocating, 4-7
renumbering, 8-5
replacing, 4-35
rotating, 4-11
searching for in open designs, 4-34
spacing, 4-12
swapping layer, 4-11
unlocking, 4-4
Parts tab
using, 4-4
Paste command, A-4, A-22
PCB
layers, 3-3
toolbar, 1-4
PCB design
default actions, 1-15
viewing options, 1-15