National Instruments Graphical User Interface Ultiboard - Page 280

Index
NI Ultiboard User Manual I-6 ni.com
PCB Differential Impedance Calculator, 6-7
PCB Properties
Board Default tab, 1-25
PCB Transmission Line Calculator, 6-1
pin type
test point, 4-25
Place toolbar, 1-9
placement
strategies, 7-5
placing a comment, 8-3
placing powerplanes, 5-11
Placing SMD Fanouts, 5-18
placing traces, 5-1
placing vias, 5-15
polygon
editing, 4-30
placing, 4-21
placing copper, 5-10
splitting, 5-11
position
of parts, 4-17
powerplanes
placing, 5-11
preferences
Preferences dialog, 1-13
pre-placed traces, 7-8
pre-placing parts, 7-2
print
leave drill holes open, 8-14
negative, 8-14
reflection, 8-14
Print command, A-3
print reflection, 8-14
programming examples (NI resources), C-1
project files
creating, 2-1
projects
renaming, 2-1
properties
shape, 4-20
R
ratsnest
about, 4-5
rectangles
placing, 4-21
redlining, 8-3
Redo command, A-3
reference point, 3-8
Renumber parts dialog, 8-5
rip-up and retry
algorithm, 7-2
routing, 7-7
router
cleanup, 7-7
router pin/gate swap, 7-11
router preprocessing, 7-7
routing
initial, 7-7
routing functions
running together, 7-8
Routing Options dialog
Autoplace tab, 7-3
Bus Autorouting tab, 7-16
Cost Factors tab, 7-12
General tab, 7-11
Optimization tab, 7-15
Rip-up tab, 7-14
Routing strategies, 7-17
rubber banding, 4-7
ruler bars
toggling on and off, 4-10
using, 4-10
S
Save All command, A-2
Save As command, A-2
Save command, A-1
Select a Net dialog, A-14
Select All command, A-5
Select Groups for Replica Place dialog, 4-14