© National Instruments Corporation I-1 PCI-MXI-2 for Linux
Index
A
A16 base address, VMEbus, 4-3
A16 write posting, VXI/VME-MXI-2, 6-20
A24/A32 write posting
PCI-MXI-2, 6-16
VXI/VME-MXI-2, 6-20
address space configuration
PCI-MXI-2, 6-17
VXI/VME-MXI-2, 6-20
arbiter type, setting, 6-24
arbitration mode, interlocked, 6-21
automatic retry feature, setting
MXI-2, 6-15
limit on (note), 6-16
MXIbus, 6-27
VXI/VME, 6-24
B
BTO. See Bus Time Out (BTO) value, setting
bulkhead cables, C-3
Bus Time Out (BTO) value, setting
MXIbus, 6-14, 6-26
VXI/VME, 6-23
C
C programs
compiling, 7-4
sample programs, 7-4
symbols, 7-4
cables
connecting MXIbus cable
VME-MXI-2 module, 4-10
VXI-MXI-2 module, 3-18
CLK10 routing, VXIbus, 3-8
SMB CLK10 settings (figure), 3-11
VXIbus CLK10 routing (figure), 3-9
CLK10 signal, MXIbus
common questions, C-3
controlling direction of, 6-14
setting, 6-14
Close VXIlibrary function, 7-4
common questions about NI-VXI/NI-VISA
software, C-1
compiling C programs, 7-4
symbols, 7-4
configuration
See also PCI-MXI-2 Configuration
Editor; VXI/VME-MXI-2
Configuration Editor
default settings, 1-9
PCI-MXI-2 board, 2-1
configuration EEPROM, 2-4
default settings
Bus Configuration Editor
(table), 1-11
Device Configuration Editor
(table), 1-11
hardware settings (table), 1-9
Logical Address Configuration
Editor (table), 1-10
PCI-MXI-2 Universal board
default settings
hardware settings (table), 1-10
quick start, 1-6
VME-MXI-2 module, 4-1
configuration EEPROM, 4-6
default settings
Configuration Editor settings
(table), 1-13
hardware settings (table), 1-13
To Next Page
Loading...
Need help?
General
