National Instruments NI CompactDAQ 9184 - Page 126

NI cDAQ-9181/9184/9188/9191 User Manual
© National Instruments | I-3
encoding
X1, 5-19
X2, 5-19
X4, 5-20
equivalent time sampling, 5-32
Ethernet
cabling, 1-29
port, 1-28
external source less than 40 MHz, 5-40
F
features, counter, 5-38
filters
digital input (parallel DIO modules
only), 4-6
PFI, 4-13
FREQ OUT signal, 5-37
frequency
division, 5-31
generation, 5-30
generator, 5-30
measurement, 5-11
Frequency Output signal, 5-37
G
generations
analog output data, 3-1
buffered hardware-timed
analog output, 3-2
digital output, 4-9
continuous pulse train, 5-27
digital output data, 4-8
frequency, 5-30
hardware-timed
analog output, 3-2
digital output, 4-9
pulse for ETS, 5-32
pulse train, 5-25
retriggerable single pulse, 5-26
simple pulse, 5-24
single pulse, 5-24
single pulse with start trigger, 5-25
software-timed
analog output, 3-1
digital output, 4-8
getting started
AI applications in software, 2-7
AO applications in software, 3-6
DI applications in software, 4-7
DO applications in software, 4-13
guidelines, electromagnetic
compatibility, 1-3
H
hardware-timed generations
analog output, 3-2
digital output, 4-9
I
implicit buffered
pulse-width measurement, 5-6
semi-period measurement, 5-10
installation, 1-5
internal source less than 40 MHz, 5-40
L
LabVIEW documentation, B-2
LabWindows/CVI documentation, B-2
LEDs, 1-26
Ethernet, 1-28
POWER, STATUS, ACTIVE, 1-26
wireless signal strength, 1-27
LINK/ACT LED, 1-28
M
MAX chassis reservation, 1-15
Measurement Studio documentation, B-3
measurements
buffered two-signal
edge-separation, 5-22
choosing frequency, 5-14
frequency, 5-11
implicit buffered pulse-width, 5-6
implicit buffered semi-period, 5-10
period, 5-18
position, 5-19
pulse-width, 5-5
semi-period, 5-9
single pulse-width, 5-6