National Instruments PCI-6703 - Page 42

Index
PCI/PXI-6703/6704 User Manual I-2 © National Instruments Corporation
signal connections, 3-6 to 3-7
specifications, A-3
DIO<0..7> signals (table), 3-3
E
e-mail support, C-1
environment specifications, A-4
equipment, optional, 1-5
F
fax and telephone support numbers, C-2
Fax-on-Demand support, C-1
frequently asked questions. See questions
about PCI/PXI-6703/6704.
FTP support, C-1
G
gain adjustment
current output calibration for 6704, 5-4
voltage output calibration, 5-3
H
hardware
configuration, 2-2
installation, 2-1 to 2-2
overview, 4-1 to 4-2
I
ICH connection as current output (figure), 3-5
ICH<16..31> signals (table), 3-3
installation
common questions, B-1
hardware, 2-1 to 2-2
software, 2-1
unpacking the PCI/PXI-6703/6704,
1-2 to 1-3
I/O connector
overview, 4-2
pin assignments (figure), 3-2
signal connection descriptions (table), 3-3
L
LabVIEW and LabWindows/CVI
software, 1-3
N
National Instruments application software,
1-3 to 1-4
NI-DAQ driver software, 1-4
nonvolatile RAM/DAC control, 4-2
O
offset adjustment
current output calibration for 6704, 5-4
voltage output calibration, 5-3
optional equipment, 1-5
P
PCI/PXI-6703/6704
block diagram, 4-1
common questions, B-1 to B-2
custom cabling, 1-5
features, 1-1 to 1-2
hardware overview, 4-1 to 4-2
optional equipment, 1-5
requirements for getting started, 1-2
software programming choices, 1-3 to 1-4
National Instruments application
software, 1-3 to 1-4
NI-DAQ driver software, 1-4
unpacking, 1-2 to 1-3
physical specifications, A-4
pin assignments for I/O connector (figure), 3-2