National Instruments PCI-6703 - Page 43

Index
© National Instruments Corporation I-3 PCI/PXI-6703/6704 User Manual
power connections, 3-7
power requirement specifications, A-3 to A-4
power supply, short-circuiting, B-1
power-up condition
current output for 6704 device, 3-6
digital I/O, 3-7
voltage output, 3-4
Q
questions about PCI/PXI-6703/6704,
B-1 to B-2
analog output, B-2
general information, B-1
installation and configuration, B-1 to B-2
timing and digital I/O, B-2
R
requirements for getting started, 1-2
S
self-resetting protection circuit breaker, 3-7
signal connections, 3-1 to 3-7
analog output, 3-4 to 3-6
current output for 6704 device,
3-5 to 3-6
voltage channel (VCH) outputs
(figure), 3-4
voltage output, 3-4 to 3-5
digital I/O, 3-6 to 3-7
I/O connector
pin assignments (figure), 3-2
signal connection descriptions
(table), 3-3
power connections, 3-7
software installation, 2-1
software programming choices, 1-3 to 1-4
National Instruments application
software, 1-3 to 1-4
NI-DAQ driver software, 1-4
specifications, A-1 to A-4
analog output, A-1 to A-3
current output, 6704 only, A-2
dynamic characteristics, A-2
stability, A-2 to A-3
transfer characteristics, A-1
voltage output, A-1 to A-2
bus interface, A-3
digital I/O, A-3
environment, A-4
physical, A-4
power requirements, A-3 to A-4
T
technical support resources, C-1 to C-2
telephone and fax support numbers, C-2
temperature sensor, 4-2
timing, questions about, B-2
U
unpacking the PCI/PXI-6703/6704, 1-2 to 1-3
V
VCH connection as voltage output
(figure), 3-4
VCH<0..15> signals (table), 3-3
VirtualBench software, 1-3
voltage output, 3-4 to 3-5
calibration
gain adjustment, 5-3
offset adjustment, 5-3
power-up condition, 3-4
signal connections, 3-4
specifications, A-1 to A-2
VCH connection as voltage output
(figure), 3-4