National Instruments PCI-8361 - Page 24

Table 1-3 provides information on which daisy-chaining boards can be connected to
corresponding targets.
Table 1-3. MXI-Express x1 Daisy-Chain Connectivity Support For Daisy-Chaining
From Chassis Targets
PXI Chassis
VXI
Chassis
PXI Express
Chassis
MXI-Express
RIO
Slot
Type
Product
PXI-
8360
PXI-
8368
PXI-
1033*
VXI-
8360T
PXIe-
8360
PXIe-
1073*
NI
9157*
NI
9159*
PXI or
PXIe
Hybrid
PXI-8364  — —
†
—
†
—
†
—
†

**

**
PXI-8367 —  — — — — — —
PXI
Express
or PXIe
Hybrid
PXIe-8364        
Express
Card
‡
ExpressCard
-8360
      
* Product has an integrated MXI-Express x1 port.
†
These configurations are not supported, even though the front panel MXI connectors are mechanically compatible.
For these configurations the boards will likely report a valid cable link via the front panels LEDs. Since these link
scenarios expose a possible data integrity issue that may not be obvious to the user, National Instruments strongly
recommends against using these configurations.
** Daisy-chaining from PXI Express or ExpressCard slots will give better throughput and latency performance than
PXI or PXI Express hybrid slots.
‡
ExpressCard slot of an NI embedded controller that is installed in the first chassis.
Note: For installation instructions and other information concerning the PXI-1033, PXIe-1073, VXI-8360T, NI 9157,
NI 9159, and the NI 3100/3110, refer to their respective user manuals.