NI sbRIO-960x/962x/963x OEM Instructions & Specifications 44 ni.com
User1 LED
You can define the User1 LED to meet the needs of your application. To
define the LED, use the RT LEDs VI in LabVIEW. For more information
about the RT LEDs VI, refer to the LabVIEW Help section at Real-Time
Module
»Real-Time VIs»RT Utilities VIs»RT LEDs
.
User FPGA1 LED
You can use the User FPGA1 LED to help debug your application or easily
retrieve application status. Use the LabVIEW FPGA Module and NI-RIO
software to define the User FPGA1 LED to meet the needs of your
application. Refer to the LabVIEW Help section at Real-Time Module
»
Real-Time VIs»RT Utilities VIs»RT LEDs
for information about
programming this LED.
Table 12. Status LED Indications
Number of Flashes
Every Few Seconds
Indication
2 The device has detected an error in its software. This usually occurs
when an attempt to upgrade the software is interrupted. Reinstall
software on the device. Refer to the Measurement & Automation
Explorer Help for information about installing software on the device.
3 The device is in safe mode. Refer to the Measurement & Automation
Explorer Help for information about safe mode.
4 The software has crashed twice without rebooting or cycling power
between crashes. This usually occurs when the device runs out of
memory. Review your RT VI and check the memory usage. Modify
the VI as necessary to solve the memory usage issue.
Continuously flashing
or solid
The device has detected an unrecoverable error. Contact National
Instruments.
To Next Page
Loading...
