Unpacking the Kit
Caution To prevent electrostatic discharge (ESD) from damaging the device,
ground yourself using a grounding strap or by holding a grounded object, such as
your computer chassis.
1. Touch the antistatic package to a metal part of the computer chassis.
2. Remove the device from the package and inspect the device for loose components or any
other sign of damage.
Caution Never touch the exposed pins of connectors.
Note Do not install a device if it appears damaged in any way.
3. Unpack any other items and documentation from the kit.
Store the device in the antistatic package when the device is not in use.
Verifying the Kit Contents
Verify that the following items are included in the sbRIO-9607 kit.
Figure 1. sbRIO-9607 Kit Contents
1. sbRIO Device
2. NI CompactRIO Device Drivers Media
3. Getting Started Guide
4. Power Supply
5. 10-pin IDC to 9-pin DSUB Cable
6. Power Cable Assembly
7. Standoffs and Screws
8. NI 9694 Digital I/O Breakout RMC Board
Note The provided power supply is only intended for the getting started
experience. NI recommends the use of a power supply that meets the specifications
listed in the NI sbRIO-9607 Specifications for system deployment.
NI sbRIO-9607 Getting Started Guide | © National Instruments | 3
To Next Page
Loading...
Need help?
General
