NI sbRIO-961x/9612XT/963x/9632XT/964x/9642XT 2 ni.com
Figure 1 shows the NI sbRIO-961x/9612XT/963x/9632XT and the
NI sbRIO-964x/9642XT.
Figure 1. NI sbRIO-961x/9612XT/963x/9632XT and NI sbRIO-964x/9642XT
What You Need to Get Started
This section lists the software and hardware you need to start programming
the NI sbRIO device.
Software Requirements
You need a development computer with the following software installed
on it. Go to
ni.com/info and enter the Info Code rdsoftwareversion
for information about software version compatibility.
❑ LabVIEW
❑ LabVIEW Real-Time Module
❑ LabVIEW FPGA Module
❑ NI-RIO
Hardware Requirements
You need the following hardware to use the NI sbRIO device.
❑ NI sbRIO-961x/9612XT/963x/9632XT/964x/9642XT
❑ 19–30 VDC power supply
❑ Ethernet cable
NI sbRIO-961x/9612XT/963x/9632XT NI sbRIO-964x/9642XT
To Next Page
Loading...
Need help?
General
