Caution Never touch the exposed pins of connectors.
Note Do not install a device if it appears damaged in any way.
3. Unpack any other items and documentation from the kit.
Store the device in the antistatic package when the device is not in use.
Verifying the Kit Contents
2 3
54
6
1
NI USRP-2920RNI USRP-2920R
1. NI 29xx Device
2. AC/DC Power Supply and Power Cable
3. Shielded Ethernet Cable
4. SMA (m)-to-SMA (m) Cable
5. 30 dB SMA Attenuator
6. Getting Started Guide (This Document)
Caution If you directly connect or cable a signal generator to your device, or if
you connect multiple USRP devices together, you must connect a 30 dB attenuator
to the RF input (RX1 or RX2) of each receiving USRP device.
Other Required Items
In addition to the kit contents, you must provide the following additional items:
• Computer with available gigabit Ethernet interface.
Caution This product is not approved or licensed for transmission over the air
using an antenna. As a result, operating this product with an antenna may violate
local laws. Ensure that you are in compliance with all local laws before operating
this product with an antenna.
NI USRP-2920/2921/2922 Getting Started Guide | © National Instruments | 3
To Next Page
Need help?
General
