National Instruments USRP-2930 User Manual

Figure 6. USRP2 SD Card Burner
7. Click the Refresh Device List button, and select the drive letter that corresponds to the
SD card interface connected to your computer. If the drive letter for the SD card interface
does not appear in the list, verify that the SD card interface appears in My Computer and
the SD card is inserted in the SD card interface.
Caution Ensure that you select the correct drive letter to update.
8. Click the WRITE IMAGES button or press <Enter> to write the firmware and images
to your SD card.
A progress bar indicates the status of the update.
9.
Click OK to close the dialog box that displays to indicate the completion of the update.
10. Close the utility.
11. Return the SD card to the USRP2 device.
12. Power cycle the USRP2 device.
13. Verify that the D LED is lit on the device front panel to confirm that the firmware and
FPGA images loaded successfully.
18
| ni.com | NI USRP-29xx Getting Started Guide

National Instruments USRP-2930 Specifications

General

Brand	National Instruments
Model	USRP-2930
Category	Test Equipment
Language	English