National Instruments USRP-2932 User Manual

10. After you change the IP address, you must power cycle the device and click Find Devices
in the utility to update the list of devices.
Confirming Network Connection
1.
Select Start»All Programs»National Instruments»NI-USRP»NI-USRP
Configuration Utility to open the NI-USRP Configuration Utility.
2. Select the Change IP Address tab of the utility.
Your device should appear in the list on the left side of the tab, similar to the following
figure.
Figure 2. Confirm Network Connection
Note If your device is not listed, verify that your device is powered on and
correctly connected, then click the Find Devices button to scan for NI USRP
devices. Your device should appear in the list on the left side of the tab.
Related Information
Changing the IP Address on page
8
The Device Does Not Connect to the Host Ethernet Interface on page 21
10
| ni.com | NI USRP-29xx Getting Started Guide

National Instruments USRP-2932 Specifications

General

Brand	National Instruments
Model	USRP-2932
Category	Test Equipment
Language	English