KONTAKT PLAYER Getting Started – 35
4.3.7 Legacy Support (INTAKT, KOMPAKT, and KONTAKT PLAYER 1)
KONTAKT PLAYER can now display and load all of your INTAKT, KOMPAKT and KONTAKT
PLAYER 1 compatible libraries. By way of loading these libraries in KONTAKT PLAYER you
can use them on Intel-based Macs again.
Note that for these libraries there is no Performance View available for the Instruments (see
section 4.4.4 for more info on the Performance View). However, some Instrument updates
may be available. Please check the library manufacturer’s website for details.
Using Legacy Libraries Installed on External Hard Drives
If you installed your KONTAKT PLAYER, KOMPAKT or INTAKT library on an external hard
drive and would like to use it on another computer, do as follows:
1. Simply attach the hard drive to the other computer.
2. Click on the Add Library button and navigate to the library install location.
3. Click on OK.
→ The Library Box will show up in the Libraries tab.
!
KOMPAKT and INTAKT libraries will show up in the Libraries tab, but the Instruments only
function once you have fully authorized the library for the new computer via the Service
Center.
4.4 Setting Basic Instrument Parameters
Each Instrument Header provides a set of controls that allow you to adjust some basic pa-
rameters, which affect that Instrument’s MIDI and audio routing, playback volume, panning
position and tuning. KONTAKT will save and recall these settings along with the Multi data.
If you’re building a multi-timbral setup of Instruments, you can use these controls to create
a sub-mix inside KONTAKT, which takes place before the nal audio is being sent out to the
audio interface or host application.
To Next Page
Loading...
Need help?
General
