What to do if my Natus Medical Equipment has interference from other devices?
If your Natus Medical Equipment is experiencing interference, try unplugging other devices on the same circuit. This includes printers, mechanical beds, vacuum cleaners, and any other potential sources of interference.
How to fix improper electrical grounding in Natus Medical Equipment?
To correct improper electrical grounding with your Natus Medical Equipment, install a medical-grade ground. This will ensure that your clinic has a properly grounded electrical system.
What to do if cables are not connected properly to my Natus Medical Equipment?
Ensure all cables are correctly connected between the EMU40EX and the computer. If using a LAN, verify that both the hardware and software are configured correctly.
What to do if patient electrodes are not connected correctly to natus EMU40EX?
Make sure the patient electrodes are connected to the correct channels in the Breakout Box.
What to do if natus EMU40EX electrodes are causing a short circuit?
If the electrodes are touching each other, they are likely causing a short circuit, which will result in an artifact. Separate the electrodes to prevent them from touching.
What to do if my natus EMU40EX Medical Equipment still has a problem after shutdown?
If the problem persists after a standard shutdown, shut down the system for at least 10 seconds. After that, set up the test again from the beginning.
What to do if electrodes fit improperly into the Breakout Box of my natus EMU40EX Medical Equipment?
Ensure the patient electrodes fit properly into the Breakout Box; they should not fit loosely.
What to do if there are breaks in patient electrode cables of natus EMU40EX?
Check the patient electrode cables to ensure there are no visible breaks.
General| Channels | 40 |
|---|---|
| Input Impedance | >100 MΩ |
| Type | EEG Amplifier |
| Resolution | 24 bits |
| Impedance Check | Yes |
| Connectivity | Ethernet |
| High-pass Filter | 0.1 Hz, 0.3 Hz, 0.5 Hz, 1 Hz, 5 Hz, 10 Hz |
| Low-pass Filter | 100 Hz |
| Notch Filter | 50 Hz or 60 Hz |
| Data Storage | External |
| Operating Temperature | 10°C |
| Operating Humidity | 30% non-condensing |
To Next Page
