38
5. Using a 15mm wrench, turn the inner portion (CP3) of the Crank
Puller clockwise. The Crank Arm will slide off as it is tightened.
6. Using a #2 Phillips screwdriver, loosen and remove the hardware that
attaches the Fender to the Main Frame. Set the hardware safely aside for
reassembly.
NOTICE: Hold the Fender so that it does not fall.
7. Loosen the Resistance Knob to the minimum resistance setting.
8. Using a #2 Phillips screwdriver, remove the hardware (indicated by
ovals) that secures the Resistance Sensor. Allow the Resistance Sensor
to hang from the Cable.
NOTICE: Do not crimp the cable.
9. Remove the Resistance Sensor Magnet after noting the at
segments are oriented up and downward. This will assist with re-
assembly.
Fender
Resistance Knob
Brake Assembly
Resistance
Sensor
Flywheel
Brake
Magnet
Resistance Sensor
Magnet
To Next Page
Loading...
