Nautilus Bowflex C6 User Manual

7
Workout with Other Fitness Apps
This tness machine has integrated Bluetooth
®
connectivity which allows it to work with a number of tness
apps. For our latest list of supported apps, please visit: www.nautilus.com/partners
Bluetooth
®
Heart Rate Enabled
Your tness machine is equipped to be able to receive a signal from a Bluetooth
®
Heart Rate Sensing device. When
connected, the Console will display the Bluetooth
®
Connected icon. Be sure to follow the described method to sync your
device.
If you have a pacemaker or other implanted electronic device, consult your doctor before using a Bluetooth
®
strap or other Bluetooth
®
heart rate monitor.
Bluetooth
®
Heart Rate Armband (supplied with the IC4 and C6 machines
only)
Your tness machine is provided with a Bluetooth
®
Heart Rate Armband. When the
Bluetooth
®
Heart Rate Armband is connected, the Console will display the Bluetooth
®
Connected icon.
If you have a pacemaker or other implanted electronic device, consult your
doctor before using a Bluetooth
®
armband or other Bluetooth
®
heart rate
monitor.
The Heart Rate Armband should be worn on the upper portion of your forearm, with the Heart Rate Sensor to the inside of
your forearm. It should be snug enough not to move around on your arm, but not so tight that it restricts blood circulation.
Note: Be sure to remove the protective cover from the Heart Rate Sensor
before use.
1. Put the Bluetooth
®
Heart Rate Armband onto the upper portion of your
forearm.
2. Push the On/O󰀨 LED button on the Heart Rate Armband to activate it. The
LED will ash blue quickly, indicating that the armband has been activated.
3. The LED will ash blue slowly when a heart rate is detected. The Blue-
tooth
®
Connected icon will activate on the Console when connected. You are ready to workout.
At the end of your workout, push the On/O󰀨 LED button to disconnect and deactivate your Heart Rate Armband.
If you press the On/O󰀨 LED button and the LED ashes red
several times, the battery is low and should be charged. To
charge the Bluetooth
®
Heart Rate Armband, connect the
Charging Cable to the Charging Terminals on the inside of the
Sensor. Connect the Charging Cable to a powered USB Port.
The LED will ash red and green while charging. When fully
charged, the LED will be green continuously.
USB Connector
Charging Terminals
Heart Rate Sensor
Armband
Charging Cable
On/O󰀨 LED
button

Nautilus Bowflex C6 Specifications

General

Brand	Nautilus
Model	Bowflex C6
Category	Exercise Bike
Language	English