Nautilus NT-CC1 - Warranty Information; Warranty Terms; Service and Legal

Assembly Instructions for the Nautilus® NT-CC1 Smith Machine
e A flat area of 9’ x 9’ (2.7m x 2.7m) will be required to assemble and properly use the Nautilus®
NT-CC1 Smith Machine.
e You will need the following tools to complete the assembly:
7/32“ (5.5mm) Allen Wrench e 5/16” (7.14mm) Allen Wrench
3/16“ (4.8mm) Allen Wrench e 11/16” (15.5mm) Box Wrench
1” (25.4mm) Box Wrench e 3/4” (19mm) Box Wrench
Floor padding, such as cardboard, to avoid scratching your floor during assembly.
A good pair of scissors will be helpful in separating parts from one another during
removal from the cartons.
e Because of precision machining, the Nautilus® NT-CC1 Smith Machine uses several
different lengths of bolts. Be careful to use the right length of bolt called for at each step
of assembly. Refer to the illustration and sizing charts provided.
e Some parts in the following assembly drawings have been assembled on the unit
prior to shipment. They are shown in the drawings for reference only in the event
that replacement parts are needed.
Bench Assembled Parts
STEP 1 Bench Assembly (see picture “Step 1”)
1. Align the hole in the threaded lug of the sliding frame (8) with one of the side holes on the main frame (1)
and insert the screw -down pull pin (9) into the holes, then secure the pin to lock in place by turning knob
clockwise.
2. Attach the bench front base (2) to the main frame (1) using two bolts (27) and two washers (28) as
shown. HAND TIGHTEN the bolts at this time.
3. Attach the bench rear base (6) to the bench main frame (1) using two bolts (27) and two washers (28) as
shown. HAND TIGHTEN the bolts at this time.
4. Now tighten all bolts used for assembly in previous steps.
5. Attach the seat adjusting lever (7) to the main frame (1) using a pivot sleeve (4), two washers (36), a bolt
(33) and a ball nut (17). Tighten the ball nut (17) securely.
6. Attach the bench backrest cushion (11) to the backrest support rails (5) using four bolts (35) and four
washers (23) as shown. HAND TIGHTEN the bolts at this time.
CUSTOMER SERVICE #: 1-877-417-0519 -- 2 -- Nautilus® NT-CC1 Smith Machine