Nautilus NT-CC1 - Get To Know Your Machine

7.
10.
11.
12.
13.
14.
15.
16.
Attach the seat cushion (14) to the seat support rails (3) using four bolts (35) and four washers (23) as
shown. HAND TIGHTEN the bolts at this time.
Attach the backrest support rails (5) and the seat support rails (3) to the bench main frame (1) using a
stud (32), two washers (37) and two nuts (19) as shown. Be sure the stud (32) is centred and then
tighten the nuts (19) to where you can still rotate the support rails (3 & 5) freely.
Attach the seat adjusting lever (7) located on the main frame (1) to the two seat support rails (3) using a
stud (32), two washers (37) and two nuts (19) as shown. Be sure the stud (32) is centred and then
tighten the nuts (19) to where you can still rotate the lever (7) freely.
Attach the backrest adjusting lever (16) to the two backrest support rails (5) using a stud (29), two
washers (37) and two nuts (19) as shown. Be sure the stud (29) is centred and then tighten the nuts
(19) to where you can still rotate the lever (16) freely.
Tighten all bolts and nuts used for assembly in steps 5-10 at this time.
Slide the leg curl/extension post (13) into the vertical tube of the main frame (1) as shown. Pull
the handle on the screw-down pull pin (9) previously installed. This will allow the leg
curl/extension post (13) to slide down. Release the pin to lock in place and secure by turning
knob clockwise.
Slide the two roller support tubes (15) through the holes in the leg curl/extension (18). Centre
the roller support tubes (15) and slide a foam roller (21) onto each end of the roller support
tubes (15).
Insert a plastic roller retaining cap (25) into each end of the roller support tubes (15).
Insert the locking pin (10) into the hole on top of the leg curl/extension post (13) only when the
leg curl/extension (18) needs to be locked in place.
Check all bolts and tighten as needed.
CUSTOMER SERVICE #: 1-877-417-0519 -- 3 -- Nautilus® NT-CC1 Smith Machine