Nautilus NT-CC1 - Machine Maintenance; Define Your Goals

STEP 2 Smith Base Frame Assembly (see picture “Step 2”)
1. Attach the left and right base rails (46 & 57) to the big foot plate (69) using four bolts (79), eight
washers (28) and four lock nuts (30). HAND TIGHTEN the bolts at this time.
2. Attach the left and right base rails (46 & 57) to the lower cross brace (51) using six bolts (79),
twelve washers (28) and six lock nuts (30). HAND TIGHTEN the bolts at this time.
3. Attach the small foot plate (61) and the stop bracket (76) to the left base rail using two bolts (88)
as shown. Tighten the bolts securely.
STEP 3 Upright and Support Post Assembly (see picture “Step 3”)
1. Attach the two rear support posts (89) to the left and right base rails (46 & 57) and lower cross
brace (51) using four bolts (79), eight washers (28) and four lock nuts (30). HAND TIGHTEN
the bolts at this time.
2. Attach the left and right uprights (47 & 68) to the left and right base rails (46 & 57) using four
bolts (88), eight washers (28) and four lock nuts (30). HAND TIGHTEN the bolts at this time.
3. Insert both of the weight bar guide rods (49) down into the rubber guide-rod cups (70) attached on
the left and right base rails (46 & 57). Insert the bolts (72) into the front holes in the cup pockets.
HAND TIGHTEN the bolts at this time.
4. With the aid of your helper, slide the weight bar safety supports (54 & 78) and the weight bar
holders (77) onto the guide rods (49) as shown. Hang the weight bar safety supports (54 & 78)
onto the desired support rods (73) located on the uprights (47 & 68).
5. Place the two guide-rod top plates (53) onto top ends of the weight bar guide rods (49) so that the
guide-rod cups (70) fully engage the guide rods (49). Insert the bolts (72) into the front holes in the
top plates (53). HAND TIGHTEN the bolts at this time.
6. Place the weight bar support sleeve (65) between the two weight bar holders (77) and hang its
hooks onto the desired support rods (73) attached on the two uprights (47 & 68).
CUSTOMER SERVICE #: 1-877-417-0519 -4-- Nautilus® NT-CC1 Smith Machine