NCR 5635 - Page 89

Maintenance Instructions
Cassette Adjustments
NCR 5635 Spray Currency Dispenser Service Manual 4-19
NCR - CONFIDENTIAL AND PROPRIETARY
Use pursuant to Company Instructions
Procedure -
4
Adjust the cassette for currency width as follows:
1
Measure the width of the currency.
2
Read off from the “Currency Width Spacer Codes” table the
codes for the E spacers and yellow spacers.
3
Cut four E spacers and four yellow spacers.
4
Put a locking wedge into the first gap in each of the yellow
spacers. Lubricate the wedge with soap to ease insertion.
5
Clip the yellow spacers into their locations in the cassette lid.
6
Screw two E spacers to each note guide.
7
Screw the note guides to the yellow spacers with the cutouts in
the note guides facing out.
Example -
4
This example adjusts the cassette for currency 67 mm
(2.64 in.) wide:
1
Open the cassette and remove the lid.
2
Remove the two note guides from the lid by undoing the cross
head screws from the Yellow spacers then remove the E spacers
from the note guides.
3
Remove the Yellow spacers from the lid by pressing in the two
spring legs of each spacer then pushing them out of the lid.
4
Measure the width of the new currency.
5
Read the spacer codes for that currency width from the code
table.
6
Set four new Yellow and four new E spacers to their spacer
codes. For 67 mm the Yellow spacer should be set to C8 and the
E spacer to E10.
7
Put the spacers on a work surface so that you can read the
letters and numbers embossed on their sides.
master.bk Page 19 Wednesday, March 27, 2002 9:35 AM