NCR 5635 - Page 90

Maintenance Instructions
Cassette Adjustments
4-20 NCR 5635 Spray Currency Dispenser Service Manual
NCR - CONFIDENTIAL AND PROPRIETARY
Use pursuant to Company Instructions
8
The E spacers have the letter E and the numbers 1 to 15
embossed on them (refer to the example given in the currency
length adjustment). The code E10 means that the E spacer is to
be cut just above the number 10. Use a sharp knife to cut the
four E spacers.
9
The Yellow spacers are embossed on one side with two sets of
numbers 1 to 12 reading in opposite directions. One end has the
letter C on it and the other has the letter D (see the illustration
below). For the code C8 you count from the C end and, with a
sharp knife, cut the spacer just above the number 8 so that you
are left with end C and segments 1 to 8.
10
Flush the spacer surfaces by removing any burrs left after
cutting.
11
Fit a locking wedge into the first gap in the cut yellow spacer
(see the illustration below).
12
Install the four new Yellow spacers by pressing the legs of the
spacer together and pushing them into the apertures in the
cassette lid.
master.bk Page 20 Wednesday, March 27, 2002 9:35 AM