Getting Started
Activating The Mas-Hamilton Lock
2-20 P77 ATM - Operator Manual
The roles of the Dispatcher and FLM personnel are as follows:
●
Dispatcher - activates:
●
the Mas-Hamilton lock in the program
●
and the Supervisor Audit (SA) key.
●
FLM person physically goes to the Mas-Hamilton lock on the
P77 to complete the activation where he/she will need the
following:
●
the initialized SA key
●
a Personal Identifier (PI) key
●
a Change key
●
a combination from the Dispatcher.
A Change key is required for this procedure. The Change key will
normally be in the possession of the FLM person. The Change key
has two prongs that, when extended, fit securely into the change
key socket on the back of the Mas-Hamilton lock. Any Cencon
Change key may be used in any Cencon Mas-Hamilton lock. The
Change key is not encoded or unique in any way.
Activate the Mas-Hamilton lock as follows:
1 Open the Mas-Hamilton lock using the factory combination (50-
25-50). Refer “Opening The Master Lock” and open the safe
door.
Caution Do not close the safe door at any time during this procedure until
Step 15.
Note: If the Mas-Hamilton lock is already in one mode and you
are activating another, someone who has the authority to open
the Mas-Hamilton lock will have to be at the P77.
2 Extend the prongs of the Change key and insert it into the
change key socket on the back of the Mas-Hamilton lock while
OPr is displayed.
3 Power the lock by turning the opening/closing knob counter
clockwise. The Change key symbol will be shown in the
display window.
Book.bk Page 20 Tuesday, July 24, 2001 9:13 AM
To Next Page
Loading...
