Getting Started
Activating The Mas-Hamilton Lock
P77 ATM - Operator Manual 2-21
4 Enter the factory combination 50 25 50.
5 After the factory combination has been correctly entered, the
ISA symbol will be displayed. Hold the SA key against the Mas-
Hamilton lock’s key reader until POC is displayed.
Note: The InI symbol will be temporarily displayed before POC
is displayed.
6 Remove the Change key (from the Mas-Hamilton lock’s socket)
and SA key (from the Mas-Hamilton lock’s key reader).
7 OPr should be displayed. Turn the opening/closing knob
clockwise to retract the bolt of the Mas-Hamilton lock.
8 Open the safe door.
9 Keeping the safe door open, close the Mas-Hamilton lock.
10 Turn the opening/closing knob counter clockwise, to activate
the bolt and charge the Mas-Hamilton lock, until EC is
displayed.
11 Turn the opening/closing knob to the home position.
12 Enter the dispatched combination.
13 IPI should be displayed. Insert the FLM key (PI key)
14 OPr should be displayed. Turn the opening/closing knob
clockwise to retract the bolt of the Mas-Hamilton lock.
15 Close the safe door and lock it by turning the opening/closing
knob counter clockwise.
16 Power the lock by turning the opening/closing knob counter
clockwise.
17 When the display prompts, IPI, insert the FLM key (PI key) that
was used to open the Mas-Hamilton lock when you started the
activation procedure.
18 The display will then show the Close Seal Number (* cxx then
xx) for the first opening, which must be relayed back to the
Dispatcher.
Note: * Where x is a number. Take note of the two sets of 2-
digits that will be displayed.
Book.bk Page 21 Tuesday, July 24, 2001 9:13 AM
To Next Page
Loading...
