Chapter 5: Service 5-13
13. Lift the edge of the Main Control Board and insert the Keylock
Ribbon Cable into the connector.
Caution: Be careful not to twist or crimp the Keylock Ribbon
Cable.
19610
Insert Keylock
Ribbon Cable
14. Replace the screws in the Main Control and MSR Boards.
15. Plug the Mouse Pad Cable into the plug on the Main Control
Board.
16. Insert the Membrane Ribbon Cables into the connectors and close
the connector locks.
17. Plug the Speaker Cable into the plug on the Main Control Board.
18. Replace the Back Panel.
19. Insert the MSR Swipe as shown in the “Removing the MSR Swipe”
section.
To Next Page
Loading...