User Information
Options
KIT INSTALLATION
IEEE-488 ADAPTER
(K804-V001)
This kit is designed for use with peripheral devices using
the IEEE-488 bus, according to the IEEE-488 Standard Digital
Interface for Programmable Instrumentation ANSI/IEEE Std
488-1978, 488A-1980.
1. The standard setting (default value) for the IFSEL
switches is 2B. If your system is using this standard
setting, continue at Step 3.
2. To change the IFSEL switch setting, remove the four
screws and cover from the adapter. Set the IFSEL swit
ches to the desired configuration; the position of the
switch and the possible settings are shown in the
following figures.
/
IFSEL Switches
To Next Page
Loading...