Follow instructions inside adapter cover:
ignore any markings on switch assembly
3. In sta ll the IEEE-488 adapter into a vacant slot at the
rear o f the NCR DECISION MATE V (s lo t s 2 to 6 may be
used)
4. Connect the plug to the IEEE-488 compatible device; i f
you are using additional cables be sure that they match
the IEEE-488 standards.
5. Check the device documentation fo r any strapping or
switch setting requirements (Talker/Listener address).
6. Refer to the CONFIG description in your IEEE-488 Soft
ware Support Package fo r software in sta lla tion proce
dures .
To Next Page
Loading...