NCR DECISION MATE V
16-Bit Microprocessor
with
Programmable Interrupt Controller (PIC) and
Memory Retention Facility
(K235 V001)
This Kit can be installed in your NCR DECISION MATE V,
provided that it is capable of executing the System Restart
by means of the CONTROL-F20 key combination (refer to the
User Information for the NCR DECISION MATE V).
CAUTION: Installation of this Kit requires knowledge of and
tperience in handling semiconductor components and other
computer hardware. It should therefore be installed by a
qualified engineer. The following installation procedures
should be carried out only by such a person.
The 16-bit/PIC board contains two wire jumper switches (SI,
S2). These must be set to the positions indicated in Figure
1, before installation of the Kit.
Installation of the 16-bit/PIC board on a multilayer board
which already contains a 16-bit processor board:
1. Remove the multilayer controller printed circuit board
from the computer. This procedure is described in the
Service Manual for the NCR DECISION MATE V.
2. Refer to Figure 3 in this description and remove the
screw marked 3. Remove the metal cover.
Doc: 017-0033472
To Next Page
Loading...