4. Refer to Figure 3. Using the longer screws (1) and the
additional PVC spacers (lc) provided with the Kit,
assemble the metal case onto the controller PCB.
3. Insert the 16-bit/PIC board into the multipin socket
which is now protruding into the metal case. Press the
multipin plug firmly into the socket. Press the 16-
bit/PIC board downwards over the noses of the PVC
stand-off clips .
6. Close the case with the metal cover provided and secure
it by means of the screw (3) provided with the Kit.
7. Re-install the controller PCB and carry out a complete
diagnostic check of the NCR DECISION MATE V.
Doc: 017-0033472
To Next Page
Loading...