Using the N3000 3-18
5.
Select Yes.
After a few seconds, the window will refresh and the selected network adapter
should now appear as disabled.
Note: The disabled card will still be visible when viewing network connections and
the Device Manager. Performing these steps will allow only one network connection
to be visible from the operating system.
Cleaning the N3000
1. Turn off the site controller and disconnect the power supply from the outlet.
2. Moisten a soft cloth with water and mild soap solution.
Note: For stubborn stains, use alcohol or an alcohol–based cleaner.
3. Gently wipe the site controller.
Caution: Avoid getting any liquid inside the site controller or its components. If liquid
gets inside, have a qualified technician check the site controller before powering it on.
Caution: Do not use abrasive cleaners, waxes, or solvents.
Caution: Do not spray the cleaner directly onto the site controller. Spray the cleaner
only onto the soft cleaning cloth.
To Previous Page
