Hardware Installation 2-12
XL7W Wedge Stand
1. Connect the USB-C end of the Display Cable to the back of the Display. Tighten the
thumbscrew.
Note: Avoid overtightening the thumbscrew by turning it only until the silver
knurled portion touches the black plastic overmold. Overtightening the thumbscrew
damages the connector on the board.
2. Remove the Cover from the Wedge Stand.
a. Swing the Cover upward to detach. The Cover has a snap fit connection on the
bottom.
b. Pull Cover in the direction shown to unlatch.
To Next Page
Loading...
