L R M - 10 – U s e r M a n u a l
14
Some applications require applying the probe’s tips on limited space. The DRM-
4015-2MM (figure below top) or DRM-4015-SP (figure below bottom) can be used
to achieve this task. To install these adapters, simply remove the standard pins
from the probe, and insert the adapter of your choice.
DRM-4015-2MM installed on a DRM-4015 probe:
Kelvin clamp probes
The DRM-4017-19 and DRM-4017-35 kelvin probes are used with the LRM-10
micro-ohmmeter to measure resistance on cables, rods, or any other metallic
surface. They integrate the four terminals measurement technique.
To Next Page
Loading...