2030434-006 Rev. E EasyOne-CS Field Service Manual Page 25
Put the front part with the keyboard back on the instrument in that way that the window is
placed over the LCD display and that the front fits tight on the back cover
Turn the instruments (front at the bottom) and turn the screws in. The holes in the hook sleeves
must be in the right position, look to the left and right side of the instrument
When you change the rear half of the housing, please remove the pocket and the serial number
label (silver label) from the old housing part and but the pocket into the rear half and glue the
label at the same position on the new rear half part.
Pocket
When you change the board with sensor, remove the old label and glue the new delivered one
onto the rear half.
Put in the 2 AA batteries, close the battery door
To Next Page
Loading...