5. SETUP
Follow the instruction for a proper touch screen usage:
• Touch de display with fingers or soft surfaces, avoid
sharp objects
• Avoid excessive pressure on the display surface
• Avoid any Contact with other electronic devices:
static discharge can damage the device.
• Avoid any contact with liquids, water, humidity: the
touch screen could not work properly
Connect the DT002 display to SunControl2. "
Once the start screen is finished, set the required data
by moving within the various screens tapping the
green button at the bottom right to continue, and at
the bottom left to go back.
NOTE
The DT002 optional display allows to modify parameters and
charge curves. If connected, the display will receive the
parameters set on the SunControl2 Dip Switch, further changes
must be made only on the DT002 display.
To Next Page
Loading...
