NEC 2000 - Page 51

Configuring the System 3-15
Advanced Menu
Menu Item Settings (default is bold)
I/O Device Configuration
Press Enter to access the following
submenus.
Serial Port A
Disabled, Enabled, Auto
Setting at Enabled allows the user to
configure the port.
Setting at Auto enables the BIOS or
operating system to configure the port.
Base I/O Address
3F8, 2F8, 3E8, 2E8
Selects the base I/O address for serial
port A.
Interrupt
IRQ3, IRQ4
Selects the IRQ for serial port A.
Parallel Port
Disabled, Enabled, Auto
Setting at Enabled allows the user to
configure the port.
Setting at Auto enables the BIOS or
operating system to configure the port.
Mode
Output Only, Bi-directional, ECP
Selects parallel port mode.
Base I/O Address
378, 278, 3BC
Selects the base I/O address for the LPT
port.
Interrupt
IRQ5, IRQ7
Selects the IRQ for the LPT port.