NEC DT530 - 3. Basic Operation: Login and Logout; DT900 Series Terminal Login Procedure; DT900 Series Terminal Logout Procedure

19
3. BASIC OPERATION
Login (DT900 Series Only)
When login mode is activated, the following procedure
is required.
(1) Enter login code and press the Set softkey.
(2) Enter the password and press OK softkey.
(3) If the login code is accepted, display changes to
normal idle status.
Logout (DT900 Series Only)
(1) Press the preassigned Logout Feature Key on
the terminal.
Note: This location is an example.
Note: Logout button is assigned by data setting at the
ECP (Enterprise Communication Platform).
(2) “LOGOUT?” is displayed on the LCD of the
terminal.
(3) Press the Logout Feature Key on the terminal
again.
Password
Login ID 2000
:
:
Cancel BK Set OK
Login ID 2000
:
Cancel BK Set OK
*****
Password
:
28 APR MON 8:45AM
List Dir ICM Prog
101
STA 101
28 APR MON 8:45AM
List Dir ICM Prog
101
STA 101
L-OUT
28 APR MON 8:45AM
LOGOUT ?
101
STA 101