10
LOCAL CONTROL KEY MODE
You can call up the MENU without the remote control unit.
You can enter the MENU directly by pressing the MENU button.
If you press the MENU button over 1 sec, the MENU will be dis-
played on the screen. : If you press the MENU button less than 1
sec, the screen will convert to AV mode.
Move the cursor to the SUB MENU you want by using the PR
UP/DOWN buttons and press the VOL B button, then the SUB
MENU will be displayed on the screen. When the SUB MENU is
displayed on the screen you can set it by using the PR UP/DOWN
or the VOL UP/DOWN buttons. Press the MENU button to return
to the previous Menu.
At the EDIT mode, you can’t use the MOVE function and DELETE
function.
NOTE
The back external terminal and the front
external terminal are common. If you use
one of them, disconnect the other with the
external equipment.
OSD HALF-TONE FUNCTION
If you press the RECALL key with the MENU displayed in the screen,
the OSD except text will be Half-Toned. If you want to return to the nor-
mal OSD, press the RECALL key again.
MODE
Pressing the MODE button on the remote control unit, the current
atcive system of the set will be displayed on the screen.
Whenever you press the MODE button, the system will be changed
as
follows :
AUTO PAL SECAM *N4.43 *N3.58
(NTSC 4.43) (NTSC 3.58)
From time to time an, abnormal system(NTSC 4.43 or PAL 60Hz) can
not be operated in Auto mode.
*In case of Models for Australia, these functions are not available.
But, OSD is displayed.
To Next Page
Loading...
