1 - 27
Configuring the Cordless Terminal
On the Bluetooth
®
handset while in standby mode, press the [HOLD] > [TRF] keys and then
press dial keys (1) to (6) to see a Setup Screen associated with the dial key pressed.
The table below lists the setting of each item.
Configuring the Bluetooth
®
Handset
The handset will return to the standby panel automatically if 4 minutes pass with
the no action being launched from the menu.
Dial key Item
Setting
([ ] default)
Explanation
(1) Base Call - Allows you to call the paired Bluetooth
®
terminal and identify it when it is
unknown.
(2) Key Touch
Tone
•Disable
•[Enable]
Set to sound a confirmation tone each time
a key is pressed or not.
(3) Ring Volume Off (0),
1 to [8] to 13
Adjusts the ring tone volume.
The ring tone OFF icon appears on the
LCD screen if the ring tone volume is
turned off.
(4) No Service
Tone
•Disable
•[Enable]
Set to sound a no service tone when no
service occurs.
(5) Low Power
Mode
•Disable
•[Enable]
Set to enter to low-power mode
automatically when no calls or key
operations have been launched for a long
time.
(6) Font Size • [Double Height]
• Normal
Set to display the characters on the two
lines in the middle of the LCD screen in
double or normal height.
* Characters will display in normal height
while a setup item is on display.
You cannot originate calls or answer terminating calls while the Bluetooth
®
menu
setup is in progress. Exit the menu before originating calls or answering
terminating calls. However, you can originate calls and answer terminating calls
with the Bluetooth
®
terminal.
Caution
Caution
To Next Page
Loading...
