67
E1 channels have to be enabled in the modem (in the AMR settings) and the connector ports enabled in the
connector as shown above. In addition, these two have to be cross-connected together. Modem channels
can also be connected to another modem so that these E1s are not available at the external connector but
are transmitted directly to the next hop.
Provisioning -> E1/STM-1/Cross-connect Setting -> Cross Connect Setting -> Add
Figure 55. Summary page, 8 x E1 channels of the modem connected to the first 8 channels of the MDR68-connector
New cross-connections can be created or removed (Add/Delete).
Figure 56. E1 cross connect setting
To Next Page
Loading...
