68
Select one channel on the Edge A side and another on the Edge B side and press OK. Repeat for additional
connections. Block selection is also possible. Element setting.
Note. Under Equipment Setup -> AMR/ Radio Mapping Configuration the number of E1 channels carried by
the radio were set for each AMR level. If the modem E1 channel setting is changed then the extra cross
connections are removed automatically.
Hold-off Timer Setting. Default is ”Disable”. Default setting.
AMR Linkage shows how many E1 channels are available at each modulation level.
Figure 57. AMR E1 priority status. Lower channel number has higher priority.
To Next Page
Loading...
