NEC M402W - ❿ after Use

30
2. Projecting an Image (Basic Operation)
❿ After Use
Preparation:Makesurethattheprojectoristurnedoff.
1. Unplugthepowercord.
2. Disconnect any other cables.
• RemovetheUSBmemoryifitisinsertedintotheprojector.
3. Retractadjustabletiltfootifextended.
(M402W/M362W/M322W/M402X/M362X/M322X/M282Xonly)
4.Slidethelenscovertothelefttocoverthelens.
5. Puttheprojectorandaccessoriesinthesuppliedsoftcase.
Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens from
damage.
Inserttheprojectorwiththelens
facing upward
NOTE:Whenplacingtheprojectorinthesoftcase,retractthetiltfootandtherearfeet.Failuretodosomaycasedamagetothe
projector.
(M352WS/M302WS/M322XSonly)
4. Reattach the lens cap
1
2
① Put the lens cap on the top of the lens.
② Push to cover the lens completely.
CAUTION:
Usecautionwhenputtingtheprojectorinthesoftcaseimmediatelyaftertheprojectorhasbeenoperating.The
projectorcabinetishot.