NEC M402W - Exiting the Viewer

76
4. Using the Viewer
Removing the USB memory from the projector
1. SelecttheVIEWERstartscreen.
 PresstheEXITbuttonwithnomenudisplayed.
2. RemovetheUSBmemoryfromtheprojector.
 MakesurethattheLEDontheUSBmemoryisnotashing
before removing the USB memory.
NOTE:IfyouremovetheUSBmemoryfromtheprojectorwithaslide
displayed,theprojectormaynotoperatecorrectly.Ifthishappens,
turnofftheprojectorandunplugthepowercord.Wait3minutes,then
connectthepowercord,andturnontheprojector.
Exiting the Viewer
1. Press the MENU buttonwiththeslidescreenorthe
thumbnailscreendisplayed.
The control bar or the pop-up menu will be displayed.
2. PresstheMENUbuttonagain.
The on-screen menu will be displayed.
3. Selectasourceotherthan[USB-A]andpresstheEN-
TER button.
The Viewer will be exited.
TIP:ToexittheViewerusingtheremotecontrol,selectasourceother
than[USB-A].