NEC M403W - Turning off the Projector

27
2. Projecting an Image (Basic Operation)
❾ Turning off the Projector
Toturnofftheprojector:
1. First, press the (POWER) button on the projector
cabinet or the STANDBY button on the remote con-
trol.
The confirmation message will be displayed.
2. Secondly, press the ENTER button or press the
(POWER)ortheSTANDBYbuttonagain.
The cooling fans stop operating when the projector turns off
and goes into standby mode. When in standby mode, the
POWER indicator will light red and the STATUS indicator
will light green approx. for 10 seconds and then will light off
when [NORMAL] is selected for [STANDBY MODE].
PowerOn
Steady blue light
Standby
Steady
red light
CAUTION:
PartsoftheprojectormaybecometemporarilyheatediftheprojectoristurnedoffwiththePOWERbuttonorifthe
ACpowersupplyisdisconnectedduringnormalprojectoroperation.
Usecautionwhenpickinguptheprojector.
NOTE:
• Whilethepowerindicatorisblinkingblueinshortcycles,thepowercannotbeturnedoff.
• Youcannotturnoffthepowerfor60secondsimmediatelyafterturningitonanddisplayinganimage.
• DonotdisconnecttheACpowersupplytotheprojectorwithin10secondsofmakingadjustmentorsettingchangesandclosing
themenu.Doingsocancauselossofadjustmentsandsettings.