NEC M403W - Projecting Images from USB Memory Device

75
4. Using the Viewer
❷ Projecting images stored in a USB memory device
ThissectionexplainsthebasicoperationoftheViewer.
TheexplanationprovidestheoperationalprocedurewhentheViewertoolbar(→page79)issettothefactoryde-
fault.
•StartingtheViewer .......................................................................below
•RemovingtheUSBmemoryfromtheprojector ....................... page77
•ExitingtheViewer .................................................................... page77
Preparation:BeforestartingtheViewer,storeimagestotheUSBmemoryusingyourcomputer.
Starting the Viewer
1. Turn on the projector. (→page15)
2. InserttheUSBmemoryintotheUSB-Aportofthepro-
jector.
• DonotremovetheUSBmemoryfromtheprojectorwhile
it’s LED flashes. Doing so may corrupt the data.
3. PresstheSOURCEbuttonontheprojectorcabinet.
The Viewer start screen will be displayed.
• PresstheUSB-Abuttonontheremotecontrol.