NEC MultiSync E658 - Page 58

English - 55
CRESTRON CONTROL Settings
Click on “CRESTRON CONTROL” on the left column below HOME.
CRESTRON CONTROL Enables or Disables managing from the controller.
CONTROLLER IP ADDRESS Sets the IP address of the CRESTRON SERVER.
IP ID Sets your CRESTRON SERVER IP ID.
PORT Sets the Crestron port used for Ethernet communication.
HINT TheCRESTRONCONTROLsettingsarerequiredonlyforusewithCrestron’sROOMVIEW.
For further information, visit http://www.crestron.com
AMX Settings
Click on “AMX” on the left-hand column on the HOME screen to enter the setting screen.
AMX BEACON When the monitor is connected to a network supporting the NetLinx control system by AMX, enables or
disables the function to send a beacon to the system from AMX Device Discovery.
NOTE When using a device that supports AMX Device Discovery, all AMX NetLinx control systems will recognize the
device and download the appropriate Device Discovery Module from an AMX server.